BLUE SEA E SERIES BATTERY SWITCH DUAL BS5511e

C$68.95
Article number: 105511
Availability: In stock

Simultaneously switches two isolated battery banks or combines battery banks to all loads

Make-before-break contact design allows switching between battery banks without power interruption

Ignition protected—safe for installation aboard gasoline powered boats

Case design allows surface or rear panel mounting

Specifications

Switch Type Dual Circuit Plus

Color Red

Switch Positions 3

Battery Combine Yes

Alternator Field Disconnect (Alternator Field Disconnect protects the diodes in the alternator in the event of the switch being switched to the OFF position while the engine is running. if the AFD is not used to protect the alternator, an LED can be connected to the AFD terminals to indicate when the battery switch is in any position but OFF. )

No Maximum Voltage 32V DC Continuous Rating (The maximum current a switch is designed to conduct for an indefinite period.) 350A Intermittent Rating )The maximum amount of current a switch is designed to carry for a minimum of a designated period of time.)

525A (5 min) Cranking Rating 10 sec (Normally associated with 'cranking current' which is the current required by the starter circuit prior to engine starting. The cranking current varies significantly during the starting cycle. Initially, there is a large surge of current required to overcome the inertia and compression of the engine. This surge can be two to four times the average cranking current. Once the engine is turning there are peaks and valleys as the pistons go through the compression and exhaust cycles. The cranking current rating is used for sizing batteries, cables, and battery switches.)

1000A Cranking Rating 1 min (The maximum amount of current a switch is designed to carry when starting an engine when the cranking period does not exceed 1 minute.)

750A Battery Inputs 2 Cable

For 4/0 AWG Cables 1.10in (27.94 mm) Cable Size to Meet Ratings 4/0 AWG (120mm²) Mounting Holes Accept 1/4" (M6) Screw Terminal Stud Size 3/8"-16 (M10) Terminal Stud Torque 140 in-lb (15.82 Nm) Weight 1.30lb (0.59 kg)

0 stars based on 0 reviews